![]() After power off/on again, the same thing happens - the signal randomly drops couple of times, then comes back and cuts out properly after a while. Works fine for a couple of hours, then goes black/no signal for good. However, after turning on the console, it would go blank screen for a minute or two, then the signal comes back. ![]() I thought it was finally OK, so reassembled the unit. So I hot-aired the HDMI ic in order to solder any loose joints, and this time it worked fine on 1080p. I tried another cable - with that one 1080p worked, but all the whites on the screen were with snowy artifacts as well as the left corner. The colors were weird, but picture was present. On safe mode it fired up, I changed the resolution to 1080i, since on 1080p there was no signal. Then the signal was fine, played for half hour, all good.Īfter a couple of weeks I turned the console on and there was the WLOD again. Replaced one resistor and a diode too (I think), which I saw on a repair video by Andrew Paul. Still no picture, so I replaced the HDMI IC from that same board and 2 HDMI filters as well. However, there was still no signal, so I checked the hdmi fuse, which was blown - replaced it with a fuse from SAA-001 board (that one has BLOD). I changed the HDMI port, couple of pads on the board were ripped, which I connected to the corresponding caps/resistors? Just did so as in a shown diagram (one of the ground pads I ripped off and left it not connected). My friend gave me an original fat PS4, board model SAB-001, with WLOD, that has been previously opened. I am not a professional, all I can do is solder stuff on the boards, so I would really appreciate it if someone with knowledge shares his experience/thoughts on a problem I have with a PS4 console.
0 Comments
Leave a Reply. |